Need Help Installing a False Bottom

Hi I just purchased the NB 10 Gallon All Grain system and, currently, I am trying to figure out how to set up the false bottom. Are you suppose to cut a few inches off of the clear 3/8" ID high-temp tubing to connect the elbow fitting of the false bottom to the barbed bulkhead (valves)? Or was I suppose to an extra few inches to install the false bottom?

Sorry, I am likely not describing this very well; this lingo is all new to me.

Looking forward to my first all grain batch, thanks!

I just snipped a couple inches off of my thermoplastic tubing to connect the false bottom elbow piece to the vavle. Just wanted to wait to make sure before I cut the tubing a bit but everything works well now. I had written that post late last night and I should have just waited to think of ways to solve the issue.

Cheers!

So excited to do my first all grain batch!

You got it right. Enjoy your all grain experience!

Thanks! i just brewed my first all-grain batch today of the Dry Dock Breakwater Pale Ale. Everything went very well and I hit my targeted OG of 1.049. Looking forward to more all-grain brewing.

Cheers!