My new brewstand

Northern Brewer General
1

So I have wanted to build a brewstand since I discovered this addiction , and I am pleased to say that this weekend I was able to make that happen :mrgreen: .

So here is a pic.
I ordered two pumps that will be here tuesday, and they will get mounted on the diamond plate.

2

looks good, you did a nice job.

3

Very professional looking. Nice work!

4

I have the same burners on my rig. You’ll definitely want to fab windscreens for the burners. Also, unless that is propane on a high pressure regulator, you won’t be able to use all 3 at once.

5

Thanks guys,

I bought a standard regulator from the hardware store, and I am planning on using a standard propane tank. What type of regulator to I need to run all three? Thanks for the help.

6

What pressure regulator should I be using? 0-2 psi? 10 psi 20 psi 30 psji? Thanks there a lot of options.

7

I’d go with the 30 PSI. You can always adjust the flow of the gas via the valves you have installed so I would get the highest pressure reg. I could find. Especially for 3 wokjets.

8

Thanks for the advice, I am going to brew up a 10 gallon batch this Saturday to break it in.

9

Before brewing a batch of beer, I recommend you brew a batch of “water” just to run the stand through the process. It will help uncover any unforeseen problems that would be easier to deal with than if you are had a real batch of wort.

10

So I ran a batch of water last night ( a good idea) and my boil is currently underway. Will need to make some heat shields so my ball valves don’t fry, and I think I am going to add a tee and valve on the discharge side of the pump to bleed air off. Other than
that, works like a charm

11

That’s nice…I wanna make one…any website I can got to to get the specs/materials I need or could someone tell me?

Thanks

NewbieJM

12

[quote=“NewbieJM”]That’s nice…I wanna make one…any website I can got to to get the specs/materials I need or could someone tell me?

Thanks

NewbieJM[/quote]

i know this is an older thread, but if you want to find a site that its pretty good on what you are going to need http://www.aleiens.com/profiles/blogs/w … dless-brew this is what i based the one i am currently working on off of. even if don’t want to do a bolt together stand and want to weld it, this will give you an idea on what you are going to need.
:cheers: